Krc connection

hi, I am a new user of kuka robots. After a reboot with repeated reading of the files, it does not want to start, namely, it does not connect to krc. Previously there was a similar problem, but it was that another employee changed the IP addresses through Windows. I've already tried connecting an external monitor and smarthmi won't load on it either

Quote from SkyeFire

"It"? What is "it"?

Is this a KRC1, KRC2, KRC3, KRC4, KRC5, Sunrise?

What does show up?

This is beginning to sound like something that will require a full KSR Image Restore.

Krc4, Windows is displayed on the monitor, smarthmi cannot start. smarthmi writes that there is no connection with krc

ошибки

Посмотреть и скачать с Яндекс Диска

disk.yandex.ru

Photos of all errors are available via the link

And I will immediately write a recovery flash drive, as well as the opportunity to get it

Quote from panic mode

details matter. connecting monitor to KRC will likely show blank screen... unless... you connect the monitor to KRC, make sure monitor is powered up and then power up krc.

please look at the message below, I will be grateful

Quote from SkyeFire

"Это"? Что это такое"?

Это KRC1, KRC2, KRC3, KRC4, KRC5, Sunrise?

Что появляется ?

Это начинает звучать как нечто, требующее полного восстановления образа KSR.

please look at the messages below

Quote from SkyeFire

Sounds like file corruption in KSS/VxWorks. This will probably require a re-install of the Windows/KSS core software.

I may have found a problem, the absence of the vxworks.bin file, I tried to install it from another robot on kss 8.3, now it complains about the vxworks version. Does anyone have access to the robot on kss 8.2.22 I only need one file from there

C:\KRC\ROBOTER\vxWorks.bin

everything is fine, krc started, found missing files