Krc connection

  • hi, I am a new user of kuka robots. After a reboot with repeated reading of the files, it does not want to start, namely, it does not connect to krc. Previously there was a similar problem, but it was that another employee changed the IP addresses through Windows. I've already tried connecting an external monitor and smarthmi won't load on it either

  • kwakisaki

    Approved the thread.
  • details matter. connecting monitor to KRC will likely show blank screen... unless... you connect the monitor to KRC, make sure monitor is powered up and then power up krc.

    1) read pinned topic: READ FIRST...

    2) if you have an issue with robot, post question in the correct forum section... do NOT contact me directly

    3) read 1 and 2

  • Krc4, Windows is displayed on the monitor, smarthmi cannot start. smarthmi writes that there is no connection with krc

  • ошибки
    Посмотреть и скачать с Яндекс Диска
    disk.yandex.ru

    Photos of all errors are available via the link


    And I will immediately write a recovery flash drive, as well as the opportunity to get it

  • details matter. connecting monitor to KRC will likely show blank screen... unless... you connect the monitor to KRC, make sure monitor is powered up and then power up krc.

    please look at the message below, I will be grateful

  • please look at the messages below

  • Sounds like file corruption in KSS/VxWorks. This will probably require a re-install of the Windows/KSS core software.

    I may have found a problem, the absence of the vxworks.bin file, I tried to install it from another robot on kss 8.3, now it complains about the vxworks version. Does anyone have access to the robot on kss 8.2.22 I only need one file from there

    C:\KRC\ROBOTER\vxWorks.bin

Advertising from our partners