Hello.
I have a fanuc robot 45kg payload with
R-30iB plus controller.
I want to use it as plasma/laser cutter or mig/mag welder.
So i need to setup I/O and external axes(linear rails and-or rotary table).
What hardware and software needed for these?
Controller has already installed profinet card with 4 ports and erthernet card.
I have wago and beckhoff I/O "slices" if i get a wago or beckhoff profinet coupler
can attach the I/O "slices" i have to profinet coupler for I/O ?
robodk and roboguide software can help?
For kuka krc2 is easy devicenet i/o
extra servo drivers+servo motors
install the tech packages and done..
How this can be done on fanuc?