Hello everyone.
We have an issue with a S4C+ controller 1400 welder .It works fine in automatic mode ,but when we change in manual mode the motors doesn't go on. It seems like a contractor is bad.
Does anyone know what's going on
Thanks in advance
ABB S4C+ M2000
-
Enio -
June 14, 2021 at 12:10 PM -
Thread is Unresolved
-
It seems that you didn't describe the problem exact enough.
It's normal that the motors are going off when you switch to manual mode.
Any messages on the TP?
-
Check that the LEDs on the Panel Unit illuminate when the deadman switch is pulled in.
Try swapping teach pendants (with power off!!).
If the contactors are working in Auto, they most likely are good. Something in the enable chain is probably missing.
-
Led's on the panel board, DSQC509
-
possibility it could be one or both switches behind the deadman on pendant but as scooter said try switching pendants
-
Information on the DSQC509 Panel Unit referenced by Lemster68 can be found in the S4C+ M2000 Procedures manual found >here< on pages 82 - 84.
Which of the 6 LEDs on the upper right come ON when the Deadman is pulled in?
-
Hello Skooter,all the LEDs on DSQC 509 are lit even when i pull the Deadman or not, Uploaded the two errors which it gives
robot-forum.com/attachment/30851/
-
Did you swap the teach pendant?
The enabling device is the deadman switch in the teach pendant.
Like 851dave mentioned about the deadman circuit switches, sometimes when one of these switches goes bad, it will give this error.
-
-
Information on the DSQC509 Panel Unit referenced by Lemster68 can be found in the S4C+ M2000 Procedures manual found >here< on pages 82 - 84.
Which of the 6 LEDs on the upper right come ON when the Deadman is pulled in?
The reference manual also found there has the diagrams!!
Advertising from our partners
