Posts by NateD

Quote from hermann

No. This would be illegal, and therefore not discussed in this forum.

NO.. It is not illegal... And yes It can be reset... and a quick google search will take you directly to the answer that doesn't even need to be posted here....

I have had anti virus software give me errors I would try it without one installed.

Its the new collision avoidance system... the robot can magnetically disconnect and reconnect..

Is the new camera weight different enough to run a new payload?

Stop being stingy with manuals and the ability to download roboguide without having to login and request... I can get robot studio and rapid syntax manual anytime anywhere.

People will most likely stay with what they have used and already learned for years.. going to be tough for people to switch from what they already like.. New programmers might be easier.

check the box "show almost found" and see if you get any results.

I did probably 200 + set ups with the force detection and it is finicky and the software has bugs.

What is the equalizer setup? are you switching it to a hard stop on the gun before checking? when teaching is the REF TCP the same as the static taught one?

I think so.. I always carry a pre jumped one with me.

You should always hit stop, it's not good to just release the deadman and have the robot hard stop and yes it might interfere with what's going on with path recovery and losing what's in memory.

Does this robot have safe move?

If set up properly measureL is better. For touch ups its best to cap change and reset tip wear to make sure you have a solid starting point.

You can also partition the USB to 2gb and that should work.

Have you tried going into setup and changing it from remote to local mode to get it going then back to remote before next job call.

Yes you can do this, just need to tool changer with the right cables and you are good to go.

You can definitely jump over it but not sure where on the older model's if you can get a copy of the e-plan you should find it there.

Based off of your tolerance needs you have several options.

You could place a middle points in between start and end with increasing speed based on the approximation of the point. or you could just keep only a start and end and dial the acel parameter to to match your exact needs.

UPDATE: I read your post again and I am concerned that by creating a timing based situation by artificially compensating in the wrong way. it would need to be a set tie in with the axis speed variable and the position.

Do you have a back up of your IO file? I would overwrite any new IO file modifications and see if that helps, but of course keep a back up of both. as far as the motion sup it may be due not re selecting the correct tcp, tool / payload, and wobj in the jog screen.

what type of stop are you performing? is it a soft stop with brake ramp? or a hard full brake stop?

Also I would suggest checking that you are using the correct load parameters for each TCP and payload you are using. Sounds to me that you need to run a new tool load or payload.