Yes i read the Remote Motion Interface OPERATOR'S MANUAL but i cant find how to connect the real robot with the pc via ethernet. I'm a robotic student and it's my first time to work with fanuc robot.
Robot to remote pc connection
-
MUNIACO -
July 16, 2020 at 9:42 PM -
Thread is Unresolved
-
-
Get an Ethernet wire.
Plug one side into the PC, the other side in the robot controller.
-
It's not that simple there is a setting that i have to do on the teach pendant.
-
.. To answer your vague question with another just as useless one..
It was only an example of what pdl told. Therefore I used the . You should ask a bit more specific. Otherwise one have to repeat the manual.
-
There's no such thing as a stupid question, but there are useless questions. You need to be more specific.
What have you done so far?
Here are exampls of a specific questios that might help you:
Can you ping the robot from your computer?
Have you setup the Ethernet port on the robot?
The port settings are under host comm under the setup menu. You'll need to set an IP address for the robot.
You'll also need to setup your computer to have a static IP address on the same subnet.
-
First, you need to read this : Eats, Shoots & Leaves
You are either ignorant or just being lazy. If you hope to some day get a job in industrial automation, people will notice your lack of attention to detail. It's the details that will make or break you in this industry.
It is incredibly difficult to decipher your last post. Your sentences run on and on, and the lack of punctuation does not help.
Are you saying that you already have a successful socket communicating with the robot?
-
Yes,now i have a successful socket communicating with the robot and also, I solved the last problem i had. Now i'm writing a c++ code to send my Instructions Packets to the Robot and i'm wondering if i need to send the whole packet or just the command i need.
example:
or
And sorry I'm not lazy or I have a lack of attention, i was just at work and i wrote the message too fast.
-