Is there a parameter that will make the SV ON READY AT DSW RELEASED invalid all the time? I switch it to invalid but it always reverts back to valid.
Servo On Ready
-
Noob1982 -
November 26, 2019 at 6:53 PM -
Thread is Unresolved
-
-
Hi Noob1982, did you find a solution to this problem?
-
see below link.
ThreadWho knows what parameter set "SV ON READY OFF AT DSW RELEASED" valid/invalid
Hi all,
Does any of Motoman gurus know which parameter I must change to set "SV ON READY OFF AT DSW RELEASED" permanent valid? The controller is YRC100.
It's a bit annoying to change it every time I reboot the controller.mil3kOctober 31, 2021 at 9:18 PM -
Management security, Under Setup/Operating condition, the last item in the list can change to allow servo to stay ready. HOWEVER, this will go back to normal every time the power is cycled.