Hi
I have question about capacity of CF cards that i can use in Motoman robots. what capacity can i use?
when i buy a need CF how can i format it for read in robot?
I will use in NX controller for save and load jobs via teach pendant.
Hi
I have question about capacity of CF cards that i can use in Motoman robots. what capacity can i use?
when i buy a need CF how can i format it for read in robot?
I will use in NX controller for save and load jobs via teach pendant.
You can use also 2gb capacity. But dont format under Windows.... The most use is 64gb
Trimis de pe al meu Lenovo TAB 2 A10-70L folosind Tapatalk
how can i format it for use in controller? are there software for it?
For just backing up, it works out of the package no formatting or software needed
XRC robots can only use Sandisk CF cards and 32 meg (yes meg, not gig.) If you have a XCP01C and new software you can use up to a 64 meg. I know you can't find these anymore. Look on Craig's list or eBay for old digital cameras. If you're lucky it will have a small (like 16 meg) cf card and you can use the camera to format the card.
If you're really stuck Google how to make a large CF card small with the "diskpart" command. Be extremely careful using the diskpart command. If you are not careful you can kill the hard drive in your PC.
I have purchased CF cards and other flash accessories for years right here. Great place to do business with.
He have nx100 not xrc
Trimis de pe al meu Lenovo TAB 2 A10-70L folosind Tapatalk
Yes. My controller is NX not XRC.
If it's NX100, then card size should be any of the following: 32MB, 64MB, 128MB, 256MB. Can't remember if you can use 512MB on NX100. I think so but not completely sure.
I use in nx100 also 2gb. But in sec max is64 mb
Trimis de pe al meu Lenovo TAB 2 A10-70L folosind Tapatalk
I'm working with a Yasnac XRC SK16X and to backup my programs, how can I do this without spending a lot of money
the only port that I see is on the teach pendant (RS-232 connector), what do I have to buy to adapt to the pendant to backup the programs????
thanks in advance for your help
get a 64mg CF and a PCMCIA adapter.
I have a link posted above in the string.
plugs into the slot on the cpu rack
Thanks Tony gast
Do you know any software to properly format the card for an XRC ?
I tried under WinXP and the card is not recognized on the XRC.
Windows 98, old digital camera, VaioSoft Recovery Manager.
If you have DX series controller, you can format your CF card under its windows, it is the best way that i check it and create a CF card for XRC.
If you have DX series controller, you can format your CF card under its windows, it is the best way that i check it and create a CF card for XRC.
If you have DX series controller, you can format your CF card under its windows, it is the best way that i check it and create a CF card for XRC.
This how is it done? I've tried and don't have the option to format by inserting the card into the console.
Do not format any card to be used in a robot with Windows. Windows will make the card NTFS and Yaskawa robots do not know what that is.
No you can not format with the DX controller.
Will a 32 GB CF memory stick work in an NX100 controller?
No, NX100 came out in 2004, so you would have to look at using CF cards with a lot less memory such as 32 MB, 64 MB, 128MB or 256MB, depending on the firmware of the robot.