Wire cut

  • Not knowing what generation of controller this is or what country this came from, makes it a little difficult to say. Looking at the screen the generation is something in the last 15 years.


    It could be OT#(2047) if it is DX100. Unlikely since I see three columns for line, step, and tool number.


    It could be OT#(4095) if it is a DX200 or YRC1000.


    Hopefully, they are labeled. Different countries have different standards. I would expect wire feed would be in the same group as the wire cutter. Which makes both output addresses above wrong.

    I know a thing or two, because I’ve seen a thing or two. Don't even ask about a third thing. I won't know it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now