HI
How do i make the wire feed a few mm before it is cut. I am touchsensing and sometimes after welding the wire aint long enough for the cutter to its job
Cheers
Wire cut
-
RobotWelder -
November 16, 2023 at 4:09 AM -
Thread is Unresolved
-
Not knowing what generation of controller this is or what country this came from, makes it a little difficult to say. Looking at the screen the generation is something in the last 15 years.
It could be OT#(2047) if it is DX100. Unlikely since I see three columns for line, step, and tool number.
It could be OT#(4095) if it is a DX200 or YRC1000.
Hopefully, they are labeled. Different countries have different standards. I would expect wire feed would be in the same group as the wire cutter. Which makes both output addresses above wrong.
Advertising from our partners
