Hello,
I am new in ABB robots, i will connect a Profibus card to ABB robot, can you explain how i can do it and what setting it needs?
Hello,
I am new in ABB robots, i will connect a Profibus card to ABB robot, can you explain how i can do it and what setting it needs?
The Controller is IRC5.
Any feedback!!
Nobody has done this work before?
You should read the ABB manual for Profibus, everything is described there in detail. If you have questions after reading the manual, come back an ask in detail.
It's too much to describe that all here in forum, and nearly every thing is in the manual.
I don't have its manual and i don't know which website can find all ABB manuals.
Please let me know the web site.
I just uploaded them to the manuals sub forum.
My experience device is..
[ IRC5 Software Option Req ]
840-2 Profibus Anybus device
[ Hardware ]
PROFIBUS DP-V1 (DSQC_667, Anybus Device)
[ GSD file ]
HMS_1811.gsd (Given to PLC Enginner. Needs for device registration)
• In the RobotWare installation folder in RobotStudio: ...\RobotPackages\
RobotWare_RPK_<version>\utility\service\ioconfig\PROFIBUS\
• On the IRC5 Controller: <SystemName>\PRODUCTS\
<RobotWare_xx.xx.xxxx>\utility\service\ioconfig\PROFIBUS\
(Use Robotstudio's "File transfer" explorer for IRC5 controller)
[ Profibus Manual ]
3HAC050965-001.pdf
[ Setup ] (in Robotstudio)
1. assign address, input size (Byte), output size (byte), add signal.
that's all.