Dear Team,
I need Support for Bellow Concerns
1) Servo -223 Alarm - DSP Dry Run alarm
2) Servo -058 Alarm - FSSB Init Error.
Both Alarm came in Fanuc robot 30 i B
After Power fluctuation this fault came ...
As per Fanuc Manual
Servo-068-DEERR alarm came all axis( After Power Recycle fault rested )
Servo-223 DSP DRY RUN (9,1)
Servo-0058 FSSB 1 init error
So Refer Manual FS1 and F4 Fuse Condition check No Issue
Then Servo Drive replaced but not ok
Then Fiber optical cable replaced still Error occur
Then Power Supply unit replaced But not ok
Then Emergency Board replaced but not ok
Then Image Backup and Robot Program Backup taken from robot
Then CUP Card replaced and Image Backup Loaded but not ok
Then Robot Back Panel Replaced again same issue came .
again we Checked servo enccoder cable then Found Cable Got Heat so Dress Pack unit Open
then 10 Mints after its got Ok
I need what is the Real issue
Pl tell us , Its help me and Other Person aslo...