Hello,
I am repurposing an LR Mate 200iC with an R-30iA Mate controller. It used to be connected to a PLC, but with this new setup, I am trying to avoid that route. I have everything set up, but I am having trouble with the e-stop board. The board is an A20B-2004-0290/03B. The TBOP8 (the one closest to the 1 and 2 amp fuses) is a 12 wire connection. TBOP9 is an 8 wire connection. I want to jumper them out for now since I wont have any external e-stops, but the instructions in the R-30iA Mate Controller Maintenance Manual (B-8272EN/06) are for a 4 and 6 wire connection. Am I looking at the wrong manual or does someone have the diagram to jumper the /03B properly?
Thanks!