Hello everyone,
KUKA:
Robot: KUKA KR300 R2700-2
Controller: KRC4
Firmware version: v.8.6.9
Workvisual version: 6.0
This is a new robot from KUKA. I create new module and adding new coordinate point with touch up method which is the name "P1". When i close module and open again this module, i can't change "P1" coordinate point. When i click "Change" there is no action. How can i change that. When i open my module on Workvisual 6.0, there is $ACCESS RV. Shouldn't that be $ACCESS RVP ?
Could you help me please about that topic?
Thank you in advance.