hi.
I'm trying to make a robotic cutting machines ... but something wrong with the pilot phase:
an example:
I tried to cut out a KUKA logo, like this:
and this is some G-CODE
Then,simulation:
it looks perfect(・ω・)ノ
I generated G-code contains only G01, so conversion of KRL(because there is no g03 or any circle)
ok.then..
Trying to run it on a machine
WTF!!!!!!!!Σ( ° △ °|||)︴
...
Then I tried some simple graphics:
In turn is 0.05m/s;0.15m/s;0.25m/s
The one on the right has shown obvious deformation
I dont know what parameters should be modified. simulation results well.
Tech mode does not seem to be the problem.
Where is my settings wrong?
thanks