It's possible to buy it from RS - just seach for Hirose plug, part no: 795-8224.
I haven't bought it myself, but when listed on their web page it should be possible to buy it.
Posts by neighbour1
-
-
Look into maintenance manual.
-
Exactly, this is how you should do it!
-
I have a chance to test it again - it's the TP problem. Switching the TP with failoure make another robot the same problem.
But it doesn't happen every time - sometimes it works without any problems
-
Use IF (ERR_NUM = '11105'), CALL KAREL_PRG
-
What robot do you have?
For some models (mechanical units), eg. R-2000 the jumper is hidden from the inside of RP1 connector - you need to disassemble the panel with all connectors and then cut the nylon band from the connector rubber cover, and it's inside.
-
You don´t need to look for a variable...Collisions are stored in MENU→0 NEXT→4 STATUS→1 Axis→ Next button→Next button again→F4 Diag.→Next button→F4 cl.det.
in this collision detect menu there are all collision for each axis
Right, but when you need to get is outside the robot eg. to scada, you have a problem to get it from the screen... of course you can read it yourself from the screen and then write it manually to scada, but who doest it like that :-))))
-
This looks like it, but your best bet is to call Fanuc Spare parts.
Thanks a lot, seems to me that's the one I need.
-
For the TP?
No, the one for the operators panel.
-
Gents does anyone know the ordering number for 2 mode switch to R-30iB and R-30iB Plus?
Thanks a lot for help.
-
As far as I remember from playing with paint robots it was set by default.
I haven't discovered this setting to change it
-
You can do it using robot ins and outs which are in EE connector (8 ins + 8 outs but the maximum ins and outs also depends of your robot type).
-
-
Could you be more precise?
In general disabling write protectin is to select your macro, then press NEXT, press F2 DETAIL and Write protect = OFF.
-
Have you tried to uninstall it and install again - I know it consumes time but maybe it helps...
Sometimes stupid things help with Roboguide
-
-
Do you have AOA backup made before the swap? Try to restore it.
-
You could use Tool_Offset, PR[x] command to the points need to be shifted, before preparing your offset in PR[x].
-
It depends what do you want to do.
The basic communication you could make using I/O's, but when you need more sophisticated things use ArcLink over DvNet or Ethernet, depending what controller you have. Using the second method you need to also buy ArcLink software to the robot.
-
Do you mean Lincoln Electric powe source?