And Disk Boot failure on the big screen
IRB6400 M94A boot discs
-
xsalt1 -
March 31, 2008 at 8:16 AM -
Thread is marked as Resolved.
-
-
Both CPU batteries should be replaced if one of them is low.
The disk set looks complete except the IRB disk is for an M96, not an M94A.
Make note of robot configuration (2.4-120, 2.4-150, 2.8-120, or 3.0-75) and whether the axis 4 motor is made by Elmo or Siemens. You will be prompted when loading software for this info.
-
ok thanks for this helpful information. but can I boot with these floppy disks? how can i imagine booting? just floppy in the drive and enter? which disk do I start with? Base Ware OS RAP 2.1 or IRB6400 2.1 Boot Disk Floppy
-
Copy all the disks before starting. ABB said to copy the original disks and safely store them. Use the copies for loading to preserve the originals.
Start with BaseWare OS RAP disk 1 in the disk drive then follow the prompts.
Multi-tasking, Serial Link RAP, and Adv. Functions are options added at the end when prompted.
Parameter disk is provided for you to store parameters on.
-
ok i will do that! I hope the disks are still okay. Floppy disks that are so old it is possible that they are irreparably damaged ...
-
I always copy floppies to the laptop first. Beware of cheap USB floppy drives that do not read correctly. Sometimes issues with a WIN10 machine but works on WIN7. If you have an old desktop or laptop with an internal floppy drive, those work the best. If you get errors, try using disk copy - I've had it work when dragging and dropping didn't.
-
When I try do Boot with the flabby disk
-
all floppy disks looked good on the pc!
-
Use a floppy disk drive cleaner in the controller floppy drive.
-
Now I have Chang the battery and become the error T1047
-
Now the cold start is running
-
What is with this leds ??
-
After few time I become the error : could not open IOC-file ...
-
after a long night I managed to restart the system. now I have some error messages, are there documents where I can read or does someone have some tips for me? many thanks
-
33156 is a missing communication with the serial measurement board. Make sure the robot-to-controller serial cable is connected.
The product manual will help, it contains the error codes. The M96 Product Manual can be found >here<.
-
Thank you very much!
My robot has an M94A controller based on the nameplate after booting I now have an M96 can that lead to problems?
-
After loading the syspar
-
I have this errors....
-
Even if I could read and understand German there is a bad glare on the screen which makes part of it illegible.
-
Sorry....
71013: Wrong type of board
DescriptionReason: Wrong type of board connected to address %d.
Check: 1. Check the board type at given address
how can i fix this problem ?
🙏
-