when we try to start the robot, it starts to load KUKA_HMI but stops at 10% and shuts down. In KUKA Cross-3 window the only error seems to be Library "FTP" not loaded (LoadDLL =0). Do you know how could we solve that?
Library "FTP" not loaded (LoadDLL =0)
-
Rausse2 -
April 15, 2023 at 2:25 AM -
Thread is Unresolved
-
-
HawkME
April 15, 2023 at 4:54 AM Approved the thread. -
What KSS Version?
-
or fix it!
-
normally one could try replacing missing or corrupt file or settings.
however that is always difficult and specially on a proprietary system.
therefore the solution is to reinstall or restore HDD from a known good image.
this is why is it always a good idea to make a backup at the right time
-
Here is a table on how vxworks reading and writing data to and from hard disk
Assuming you have KSS V5 then the FTP Server from IIS is used (and Cross3FTP.CIE is deactivated)
(only one FTP Server may run at a time)
You can check whether the Service FTP Server is running and try to start him again.
You can also try to start the Cross3FTP Server by switching LoadDLL to 1 (in registry).
Under Directory you will see all accessable directories
If this is not working you should follow panic modes suggestion