Hello,
I use Fanuc 100ic R30iB.
I have a lot Touch Sensing stick points in my programs, something around 300 but I have only 200 [PR]. May I use the same [PR] in different programs to master Touch Sensing points? I use fillet lap method.
Hello,
I use Fanuc 100ic R30iB.
I have a lot Touch Sensing stick points in my programs, something around 300 but I have only 200 [PR]. May I use the same [PR] in different programs to master Touch Sensing points? I use fillet lap method.
You can increase the available amount of PR in controlled start of the controller.
The maximum I was able to get was 360 PR. Is there a way to increase this even more?
There are round about ways to do so. How many do you need?