Hi everyone,
Here is my setup:
KRC4 compact & KR3
KSS : 8.3.38
WorkVisual 5.0.5 build 600
options :
- Ethernet KRL 2.2.9
- Fast Send driver 4.0.3
- KRC4 EthernetIP 2.0.3
- Usertech 3.3.5
I would like to test Fast Send Driver in order to send to my PC TCP and axis data at high frequency but I'm struggling with the last steps. I chose the KLI variant as proposed on the manual. I managed to install correctly the FSD package, configure my virtual network on the IP address 172.21.1.1 and i can see on the Diagnostic Monitor the modules "FSD", "FSD Interface" and my module that I named "fsd kli". I configured my fixed IP address on my PC in the same range that the one used for FSD : 172.21.1.2 and I can ping correctly the 172.21.1.1 address.
I decided to use SocketTest.exe which allow, in a very simple way, to send and receive UDP packets. But now, when I try to send the HELO packet from my computer is order to register myself as a client, nothing happen. On the "FSD" module the line "IP address of the client" is still "N/A (no client)". But every time I send a packet from SocketTest, i can see on my "fsd kli" module that the RX counter and the TX counter is incrementing. I tried to disable my Firewall but still nothing...
Am I missing something?
Thank you for your help
--