When I'm in step mode, even the programs i'm running concurrently step line by line. Is there a way to have the controller only step through programs that are called, not ran? It would make my testing go a lot faster.
Step Mode and Multiple Control (RUN 'Program') -
-
jbabineaux -
January 24, 2020 at 6:19 PM -
Thread is Unresolved
-
-
Solved that one quicker than expected. If the program being ran is set to "Ignore Pause" in program details, if that program is ran within another program that you are stepping through, it will ignore the step and run completely through.
-
I've only run into this a few times, and was never able to come up with such a simple solution. Thanks for sharing this with the forum.