i am having a hemming project. i need to give a tool offset for dry run in the hemming tool.
i need to know the instruction for tool offset to put my cell in dry run.
thanks in advance....
i am having a hemming project. i need to give a tool offset for dry run in the hemming tool.
i need to know the instruction for tool offset to put my cell in dry run.
thanks in advance....
you need to change TOOL_DATA[x]
you need to change TOOL_DATA[x]
if you dont want to Change tooldata you can also use the geometric operator
After Bas(#Tool, x) you can put $Tool = $Tool:{x 0,y 0,z 0,a 0,b 0,c 0}
so that the normal tool data aren't edited.
Kind regards,
Nomad
@NoMad
this will work only if no ILF are used
Thanks all of you.
Its not a useful information, not working.....
as mentioned, you need to either change TOOL_DATA[] or learn about hemming and TOOL_CORR_ON