I know there is an easier way to load jobs from an sd card onto nx100 by overwriting the programs.
Currently we have to delete the job from the pendant and then we are able to load. Previous robots allowed me to overwrite just not sure why this one does not.
Load Job onto NX100 from SD Card -Delete First
-
dannyboysd89 -
April 25, 2016 at 9:34 PM -
Thread is marked as Resolved.
-
-
Change RS059=3. This will give you the ability to overwrite from the pp to cf and from cg to pp.
-
I hate to ask, changing RS059, is this done on the pendant, or is this a switch inside of the nx100 controller.
-
That's another parameter just like the s2c, etc. RS are the ones for communication. For baud, parity bit, etc etc
-
You will find it in MANAGEMENT mode under the PARAMETER icon.