Hello everybody,
i am wondering with a problem that my krc2 robot hard disk is currepetd so i have to install all system software with new ine hard disk plz give me this manual
or guide me
how to installed system software in kuka robot
kuka krc2 robot system installation manual
-
Egaleskay -
September 8, 2014 at 7:32 PM -
Thread is marked as Resolved.
-
-
Do you have the install CDs?
Do you have a good Archive of the robot?
Did you ever make a system image when the robot was working properly?
-
i have install CD
-
you need install CDs not one CD:
1. windows
2. kss
3. any tech package your robot usesif you don't have good archive, your programs and settings will all be lost if you attempt new installation.
depending on type of problem, they may be lost already but if possible one should first attempt recovery of tech packages, programs etccontact kuka
-
i have all packge CDs
kindly guide me as same -
You will need a mouse and keyboard. USB should work, but some older KRC2s may require PS/2 instead.
To perform a complete re-install:
1. Boot the robot with the Windows CD in the CD drive (it may be necessary to tell the BIOS to boot from the CD)
2. Once Windows has been completely installed, boot the robot normally, get to the Windows desktop, then insert the KSS CD and run the SETUP.EXE file on the CD (the file name may be slightly different on different generations of KSS).
3. There may be an anti-virus CD -- install that next
4. Proceed through the Tech Package CDs one at a time. It mostly does not matter which order, except that if you have a UserTech CD, install that one first. -
thank you very much
-
I would first try to recover programs, tools, bases etc and any tech packages from D: drive (just in case).
-
Mmm... yes, probably a wise precaution.
-
I need to KRC2 KSS CD setup .Please Can you give Link?
What is the fault of the solution? can you help me?
-
http://www.kuka-robotics.com/en/support/
make sure to have info such as robot and cabinet serial number.
-
http://www.kuka-robotics.com/en/support/make sure to have info such as robot and cabinet serial number.
Please help me, I need to KR C v4.1.6 setup file.
-
All robots are sold with drawings and software. If you lost it contact Kuka. If you bought it second hand talk to your seller. Do not ask for software here...
-
-
Hi
I have one KRC2 and wr have problem in hdd can I recovery our data?
-
depends on nature of the problem. of the HDD was incinerated, melted down, hammered or ground into fine dust i think it is fair to say that there is not much hope for data recovery.
if there was a head crash and you did not run it much since the failure, it may be possible to recover data from some areas, where the disk surface was not damaged.
if you are lucky and hardware failure was on the PCB, then chances of recovery are rather high if you can replace the electronics with good one. this is commonly done in data recovery.
if you have HDD in working order but problem is data corruption, then you can recover data as is - corruption included.
-
i have install CD
Could you please share Windows and KSS installation CDs
-
No we can not. We do not support software piracy of legally protected software. Talk to KUKA.