Hello,
Currently I can use 100 position registers. Am I correct this count is limited by setting?
How to configure this limit?
Thanks in advance.
Onno
Hello,
Currently I can use 100 position registers. Am I correct this count is limited by setting?
How to configure this limit?
Thanks in advance.
Onno
go to controlled start and then program setup, I believe you can have 200 max
Thank you very much!
This did the trick.
I remembered the 200 max, but couldn't find the setting.
Best regards,
Onno
is it possible to increase the number of PRs over 200 ?
depending controler you use. With R30iB you can have 300 PR maybe a little bit more but I'm not sure on last part of my answer.
I only know this because I had to look it up this morning myself, but according to the HandlingTool eDoc-"You can increase the number up to 2000(for single group systems)". It doesn't mention a number for multiple group systems though.
in the controlled start menu under menu 0- next 1-program setup
Thanks folks, worked for me! I set it to 200.
depending controler you use. With R30iB you can have 300 PR maybe a little bit more but I'm not sure on last part of my answer.
R30iB Plus and I can set 373 PR max
R30iB Plus and I can set 373 PR max
This is unique for every controller and the installed software options. Some will have more, some less.