Posts by onno
-
-
Currently I'm working on this too:
Special attention when using Microsofts ftp-client!
I started with this client because of the scripting function. With ftp.exe -s scriptfile I could up- and download a predetermined file set.Using get command, a .tp file is downloaded to your pc, but you can't put this file back to your controller.
The controller didn't accept de malformed file with error response 'Prog uses un-installed options'
I lost the file on the controller, because the file on your controller is deleted as soon as you start uploading the same filename.After examination of a downloaded file and a the same copied file on usb I discovered the reason:
For every 0x0A linefeed character there is a preceding 0x0D return character in the malformed file.To correct the malformed file I had to change the 0x0D 0x0A combination to 0x0A, every 0x0D not followed by 0x0A must stay.
Total Commander downloads the files correctly.
Regards,Onno
-
Hello,
How to setup Roboguide in a way that a connected HMI(Monitouch) can change registers and IO?
Used controller: Ri30A
Goal: Testing a real HMI connected to computer running RoboguideThe real world robot and HMI-panel configuration is working.
The connection I'm using is ethernet, used protocol on HMI is 90 Series SRTP communication.
As Roboguide is simulating the webserver fine, I asume the SRTP communication should work, but for SNPX/SRTP port 18245 is not open (firewall also disabled).Please, tell me if this is possible.
Thanks in advance,
Onno
-
Thank you very much!
This did the trick.
I remembered the 200 max, but couldn't find the setting.Best regards,
Onno -
Hello,
Currently I can use 100 position registers. Am I correct this count is limited by setting?
How to configure this limit?Thanks in advance.
Onno