a bit expensive, as on the market there you can find a second hand Kuka rotary 7th axis for around 4000 EUR. Bu t anyway, thank you for the offer.
I have the A1, A2, and A3 motor, also KSD 1-16...
how much would you charge for the motor cables and the KSD for A3 motor?
KRC2 7th axis setup
-
cezex -
October 22, 2013 at 3:21 PM -
Thread is marked as Resolved.
-
-
800€ for robot-forum members
-
Hello to everyone.
I'm planning to add a rotary table to my robot.
I've a kuka servo (1FK7081-5AZ91-1ZZ9-Z) and a KSD1-16 module (00-122-285).
Do you think that this combinations is OK?
Thank you. -
[size=1em]1FK7081-5AZ91-1ZZ9-Z... is Siemens and not Kuka name or article number.[/size]
[size=1em]1FK7081-... is sizeH motor, likely either 00-121-216 or 00-115-925.[/size]
[size=1em]Either way 16A KSD will do.[/size] -
Thank you for the reply!
When you said in the previous post "heap little PCB style wire-to-board connector" in the RDW box of the robot... Do you know the type of connector? Is hard to find the exactly connector. I don't want to pay kuka hundreds of €€€ for a cents connector.
In other hand, do you know the reference of the Toroidal cores installed in the KRC2 units?
Thank you so much. -