Hi all. Just wondering if there is a way to "remark" an instruction so it gets read/scanned like a comment? Rather than use jump lables.
Thanks
DX100 Rem an instruction
-
cunaf -
March 5, 2013 at 4:29 PM -
Thread is marked as Resolved.
-
-
I'm going to go with no.
You can open a job in notepad and place an apostrophe in front, save it, and reload into the controller. I've done this but can cause issues with other people or myself with why this line did not execute. It gets difficult to see that apostrophe on the screen or on a computer.
-
No. Nothing like this
-
If you open the job offline you can add a single quote (') before an instruction to make it look like a comment then load the job back in.