Posts by aytac balaban

I have changed these sockets many times and I am doing it. I didn't have any problems

Does anyone have any ideas on this subject

Hello everyone,

Which reader should I use to upload to the dsqc 564 flash disk used in the S4c+ controller?

Do yu have a circuit diagram for that part?

Thanks for your answer, is there any problem When these jumpers are installed incorrectly or missing (quad instead of double or vice versa)

Hello everyone,

I saw jumpers under the cover at the bottom of krc2 ksd drives, sometimes they are double sometimes quadruple, does anyone know what they do?

Thank you for answers,I entered the serial number that I found from the xml file by connecting via robot studio and the problem was solved.

Thank you for your help,but I cannot enter properties because there is a system failure error

I have an irc5 controller I am getting error ''20573'' controller id is missing. I reinstalled the system but the problem is not solved. Can you help if you know about this error?

Thanks for your help. The problem has now gone one step further. I inserted the jrm3 socket wrong on the main cpu board and the card burned out. I will try what you said after solving this problem.

hello everyone,

I have rj2 controller.My problem is I would like to take a backup.I connected kflopyy,but when Itry to take a backup ,''accesing device.prev to exit'' text is displayed on the teachpendant.

How can I solve this problem?

I'waiting your help ..

Thanks for this info.I brideged the green (ps_on) and black wire at the atx socket,but the resultis the same.

Other wires in the socket have not voltage.

I saw that there is no power on the motherboard during my checks. When I measure the power supply output, there is no value. Could the problem be the power supply?

Hello everyone,

I'm getting these error in krc4.I connected external monitor but nothing came to the screen.What could be the problem?

I'm waiting your

Thanks a lot panic mode,I renewed the xna cable and the problem was solved.

Hello everyone,

I have a krc2 sr controller.My problem is emergency stop.The problem is the xna cable but I don't have electrical diagram.

Would you share if there is a circuit diagram?

I'm waiting for your

Thanks a lot Diogo,

Yes, as you said, I think there are half bridge drivers on kraft cards for phase switching.

I saw current transformers and mosfets on the bas card, they must be for current measurement. But I didn't fully understand the dsp card.

Exactly what it controls and how it works,and I saw codes A04, A03, A01 on the labels of these cards.Is there a certain configuration?

I'm waiting your help .

Hello everyone,

I have m2000 ırb2400 drivers for example dsq346e. When I examined this driver I saw it consisted of 5 cards (KraftE,KraftC,KraftB,BasECB and Dsp-Kort). What are the missions of these cards?How do they works? I need to know these to understand the structure of work.Can those who know help?

You are right the problem was the reverse connection of the batteries.I'm really grateful for your help

Hello everyone,

I have a krc1 controller.My problem is when the robot is off I just plug the x 202 socket in pm-600.F1 fuse of batteries at pm 600 fails.I tried different pm600,same problem continues.

I added the relevant scheme.What could be the problem?