Hello all,
I've found an issue when attempting to send programs from K-IDE to the robot I am connected to.
I start out by receiving the AS file from the robot. All of the move instructions in the programs look like the following:
Ii comes into K-IDE with the space in between 'CL1' and '='. It is not this way in the robot, there is no space between them.
K-IDE gives an error for every single move instruction. If i manually remove the space between the tokens, the programs are sent to the robot without issue.
If I pull another AS file, even immediately after pushing the modified programs, the programs will come into K-IDE with the spaces again.
Has anyone seen this before and know how to alleviate this? Looks like a possible difference with two versions of the compiler on K-IDE vs the robot.
Thanks!