Where should ı look for the fault ?
-
socal -
April 29, 2024 at 7:54 AM -
Thread is marked as Resolved.
-
- Go to Best Answer
-
Roland Keller
April 29, 2024 at 8:35 AM Approved the thread. -
Check wiring and forum Read First.
-
thank you
-
- New
- Best Answer
Looks like your robot may have run int oissue with A5... then A6 lost mastering as well since wrist aes are coupled. this can happen when there is a collision/vibration or cable problem or external interference (welder not grounded correctly etc.)
-
Thank you panic mode. I will do what you say
-