Hello esteemed colleagues!
I am trying to automate the Camera Calibration Data on IRVision 2D by running the following commands:
17: VISION CAMERA_CALIB 'UF_TEST' Request=1 ;
18:L PR[100:zero] 100mm/sec FINE Offset,PR[4:offset] ;
19: VISION CAMERA_CALIB 'UF_TEST' Request=2 ;
The thing is, I noticed that the Position of Cal. Grid Relative to App. UFrame does not update automatically when I run the commands above (see attached). So if I change the UF the calibration will run with no errors however all the results will be wrong, because the frame of reference is not the same as before.
How can I fix this? I could not find the System Variable nor the command to update this parameter.