Import IO on robot

    Hello all,

    I need to import a .csv file containing the "io comment export" from Roboguide.

    Whenever I try to import the modified file on my roboguide, it loads just fine, but on the real robot, it says "File not loadable".

    Does anyone know why or how could I load this file via USB?

    Thanks in advance...

    "Hell...Yesterday it was workinG... I sweaR" :o)

    • Best Answer

    Is the IO config the exact same as the robot? If so we you can load a file that has the IO config and comments combined, it id diocfgsv.io. Then requires a reboot. Please take a backup first before loading that file.

    There isn't a way to import only comments in a file without writing a Karel program or custom software.

    Woah! It worked perfectly, thank you so much!!!

    Just in case anyone has this issue:

    - Make a backup of the real robot.

    - Import it on Roboguide - create cell from backup.

    - Export IOcomments.csv and modify it (\Documents\My Workcells\(yourCellName)\Exports

    - Import it back on Roboguide.

    - I used the FCTN-0.NEXT-2.SAVE on the I/O pages that I modified, just in case...

    - Make a backup via virtual TP. (the route should be \Documents\My Workcells\(yourCellName)\Robot_1\UD1.

    -Get the diocfgsv.io from that folder.

    -Load it on the real robot and cycle power!

    Thanks again HawkME!

    "Hell...Yesterday it was workinG... I sweaR" :o)

Advertising from our partners