ABB Robot is dead in the water.
Description:
During startup, no comms was establilshed with unit <DNET_Leftside_Tool> on bus <DeviceNet1>.
Consequences:
It is not possible to access the unit or signals on the unit.
I have only worked on FANUC and Yaskawa in the past. This sounds like an ethernet cable situation if it were FANUC. The problem i am having here is the robot tool is about 10 feet in the air an dI can' jog it down to check comms on the tool (without a ladder of course). Can anyone help point mei n the right direction on this?