Hi, has anyone encounter this problem? I tried to create a workcell in Roboguide with this particular robot, M-900iB/330L, which doesn't display full body of the robot. For other models, they work for me, but for some models, they display as shown. Anyone can share the solution to this problem?
Robot display body like straw/stick
-
ConfuseGuy -
June 27, 2022 at 11:10 AM -
Thread is Unresolved
-
-
kwakisaki
June 27, 2022 at 2:13 PM Moved the thread from forum General Discussion of Industrial Robots Only to forum Fanuc Robot Forum. -
Never seen this before on Roboguide.
Anyway, what RG version are You using?
And are You trying to create this virtual robot from scratch, or uploading a backup from a real robot?
-
Never seen this before on Roboguide.
Anyway, what RG version are You using?
And are You trying to create this virtual robot from scratch, or uploading a backup from a real robot?
I use version 9.4, and I was trying to create from scratch, which I use a specific model M900iB-330L. However, when I use other model such as M900iB-400L, it displays normally.
-
Has anyone else seen this or figured out a solution? I am having the exact same issue with multiple robot models. Creating from scratch or from backup.
RG version 9 RevD
build ID 9.1043.00.08
-
M-900iB/330L displays fine in V9 Rev.ZG