Hi all
I am trying to connect one of our robots to asset centre through FTP but cannot pull files even though i can make a connection through the command prompt. Here is my situation:
Computer 1 (192.168.122.250) and the robot (192.168.122.251) are on the same subnet, can communicate, and i can push/get files through FTP in the command prompt normally (ftp, binary, prompt, mget *.*).
Computer 2 (192.168.54.107) can ping the robot (and the robot can ping it), and the firewall rules have been set up so it can communicate over port 21 (verified through powershell). However when I run the same commands in the command prompt, I can't pull any files. My mget *.* command never starts/completes, and assetcentre also can't connect in its dialogue box.
Interestingly, i can set up a network FTP connection in windows explorer and SEE all of the robot files, but can't access them. If i try to open them, it fails, and if i copy one to my desktop, it's of size 0.
So it seems like all of the comms are in place, but something about pulling the files from computer 2 is not working, whereas it is on computer 1.
Any ideas?