Hello.
I have the profibus pci card and wago profibus i/o slices shown in photo.
Except of profibus cable what other need to connect a robot mig welder with 19 pin interface shown in the photo?
Welder has 2 0-10V analog inputs one is for selection of 0-63 welder programs
and the other 0-10V analog input is for mig voltage selection.
Because i haven't arctech analog tech package(only arctech digital)
i will make a breakout pcb that get as input 6 bits 2^6 and output 0-10V analog for the welder input
so i will have selection of 64 programs digitally.
How to configure profibus pci card and wago i/o module ?
What software needed ?
Also what is easier for this use-case scenario
interbus , profibus or devicenet ?
I have only interbus and profibus wago i/o modules not devicenet so i prefer profibus/interbus.