Hi Team,
I'm a long time lurker who has acquired a ZX200S (because why not!) with a couple of C series controllers.
I'm slowing working everything out, but am stumped on ethernet communications.
When plugged into my laptop, it behaves as if nothing is plugged in.
I've tried Patch and Cross Over Ethernet leads.
I've found the IP address in the robot data, and set the PC to a similar IP on the same subnet.
Using info in this forum I've enable the Circular interpolation option, and am wondering if ethernet needs enabling as well?
as the manuals reference ethernet as an 'option'.
Or is it sounding like a bad 1HA board? Which case I'll swap it with the spare controller (Haven't Yet, as not sure of implications).
I'll be sure to try another laptop tomorrow just in case..
Any thoughts on the matter would be much appreciated.
Alternatively could I up the baud of serial?. I assume loading something like this:
(where 9600 is replaced with a faster speed)
.ROBOTDATA1
SETSIO 9600 2
.END
Cheers
-Dave