Fanuc Payload & Inertia Setup

  • I know this topic has been discussed in other threads. However, I am still not 100% clear.


    I have attached an image showing my tooling setup including the calculations for Inertia ( I am using Creo in this case)


    Note: in my image the Robot TCP is the center of the orange circle plate (labeled x, y, z in the image).


    I want to make sure I am using the correct values for inertia as highlighted in the red boxes.


    I understand that I need to convert the units from mm^2 to cm^2. Also, I apparently need to divide everything by 980 to convert from kg to kgf.


    So my results would be:


    Ix: 0.909 kgf*cm^2

    Iy: 0.953 kgf*cm^2

    Iz: 0.084 kgf*cm^2


    What do you think? Does this look close?


    Thanks

  • AD
  • You are using the correct moment of inertia axis, but your reference coordinate system is wrong.


    Z needs to be out of the faceplate interface, and X needs to be to the top dowel.


    Also, contact your Fanuc rep, and ask for the latest version of the payload checker excel sheet. You can input the numbers you got from creo into it, and it will tell you if the robot you selected is within payload or not.


    Judging by the size of your wrist bolt pattern, you would be fine.

    Check out the Fanuc position converter I wrote here!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now