Hello
I have issues loading the software. IRB6400 M96 ( all siemens motors) 2.8 -1.2 S4
The problem is if i select that i have all siemens motors ( Option M96) after that it asks for boot disk 2.
I insert the boot disk 2 of 2 and press. Ok. It answers me incorrect boot disk. Insert boot disk2 and press ok. I sure that i have selected correct disk from emulator and press OK again.
Then it will say Startup error config-1 and goes on.
But nothing works after that.
If i select siemens ( 1-4 siemens motors and 5,6 elmo), then the installation will finish as it should be, no errors at all.
But if i try to arm the motors it will says :
Low current fault on drive unit 1, 2, 3, 4,5,6.
I assume that i should choose the M96 ( all siemens motors), but it wont install it.
What to check or do ?
Tried to make new disks to emulator. No results.
Tried to install software again and again about 5 times. All same issues if i choose M96.
Tried to swap the drive unit boards with new ones, still same errors. ( With Simenes option and M96 option ).