Hello everyone,
First off, I am sorry if I am not up to speed on advanced programming techniques. I am programming relatively basic welding programs on an old RJ3iB and I have run into a problem which I haven't seen in the 6,5yrs of working on this robot.
I created a welding program by normal means. Nothing elaborate. When I finished, I backed up the program to memory card, as I always do.
When it came time to use the program, I attempted to load it from the memory card and I got the following:
SCIO-016 Prog uses un-installed option
Attempting to load it to a current backup in Roboguide gave the same message.
I tried loading it to an older backup in Roboguide and also received the same alarm.
I have not been messing with any of the installed options, and I cannot figure out how this has happened.
Does anyone have any hints as to what I can do? Any ways in which I can see what changes in installed options? Since I cannot figure out how to load the program to controller, or roboguide, I havent been able to figure out what has changed.
Thanks to all