Hi engineers
i have this message on KCP :
DRIVES CONTACTOR OFF, INTERMEDIATE CIRCUIT LOADED !!!
i have two question:
1- what and where is intermediate circuit???
2- could be this message because of ballast resistors?? or there is other causes
Hi engineers
i have this message on KCP :
DRIVES CONTACTOR OFF, INTERMEDIATE CIRCUIT LOADED !!!
i have two question:
1- what and where is intermediate circuit???
2- could be this message because of ballast resistors?? or there is other causes
Dear is your problem solved
how it is solved, i am facing same problem.
please tell
+91-8360497280
In hand mode You have Drives On , can You run robot
in hand mode ?
In hand mode You have Drives On , can You run robot
in hand mode ?
not in hand mode nor auto
Dear is your problem solvedhow it is solved, i am facing same problem.
please tell
+91-8360497280
ok
KRC1 or KRC2 or KRC4 ?
[size=2]this message is only a status message, not a fault, and you are not reporting it correctly. you need to look at all messages, state message numbers and look at order of messages (see READ FIRST).[/size]
[size=2]intermediate circuit is a DC bus supplying power to servo drives. [/size]
KRC1 or KRC2 or KRC4 ?
KRC2
[size=2]this message is only a status message, not a fault, and you are not reporting it correctly. you need to look at all messages, state message numbers and look at order of messages (see READ FIRST).[/size]
[size=2]intermediate circuit is a DC bus supplying power to servo drives. [/size]
ok, i will let you know the other messages