Hello all,
I have 2 questions I am pondering:
Q1 I'd like to change my robot to have an IP of 192.168.0.xxx - I've tried doing this using the station setup>install process but found the robot uncommunicative afterwards robot OS running and OK but comms down (i pinged it and wireshark etc) can I not change this ip to certain addresses?
Q2 The station setup process almost always results in the robot operating system not functioning. ie. I install the setup then the robot and pendant goes into some kind of hung trance. It's always done this and I just avoid doing the setup process because of this.
Does anyone else have the same experience?
thanks