I have been searching Fanuc's website, but I just cannot find what I am looking for.
I am looking to find the stopping time and distance of an M410-160 robot. Especially when we are 100% and enter the DCS area.
Thanks
I have been searching Fanuc's website, but I just cannot find what I am looking for.
I am looking to find the stopping time and distance of an M410-160 robot. Especially when we are 100% and enter the DCS area.
Thanks
You have to call up the tech support line to get that information.
Thanks Nation. I was trying to avoid that. One would think it would be documented somewhere. Sigh, again.
If you have DCS you can view the defaults at the stop predication setup menus
Thanks tre. Found it, and everything is disabled and set to 0. Guess I have some reading to do...
Try setting it to default and see the results........ Might show what your looking for.
Try setting it to default and see the results........ Might show what your looking for.
Yup, it put numbers in there. Now to see if I can run production that way. Not very much room between the robot and the safety fence.
Thanks for the help tre4175