I have a Fanuc LR Mate 200IC. I have di/do connections on crma58 & crma59. The I/O on 58 works but I cannot get any out put on 59.
Any suggestions?
conversion board crma58 & crma59
-
stein -
February 23, 2017 at 3:15 PM -
Thread is marked as Resolved.
-
-
How did you configure the configuration settings? Please explain a little more ...
-
Anybody here has the manual for this conversion board?
I found this on internet but looks that I need section 4.3.1 -
Check the maintenance manual of the R-30iB Mate and Mate Plus controller (e.g. B-83525EN/09) for further information.