Hello
We provide a new programming pendant for NX100 controller. We install it on controller but it couldn't start up and it go on first page same as picture. What is problem and what must i do?
New NX100 Proggraming pendant
-
TSGIR -
February 10, 2017 at 12:23 PM -
Thread is marked as Resolved.
-
-
That's an paint/ISP pendant. Just to make sure, have you installed in on a paint/ISP robot? I don't think that pendant can work on a non-ISP robot....
-
Yes it is for paint robot. We provide this pendant for spare and its code is same as before pendant that we work with it. Therefore it must work,too.
What's your means about ISP? -
Intrinsically safe.
Did you get the pendant directly from Yaskawa Motoman, or from someone else?
-
We get directly from Yaskawa.
-
software miss match. You'll have to call Yaskawa.
-
Thank you.