Dear Collegue,
it's possible to swap the RDC card from KRC1 with the RDC card from KRC2?
Thank You
Dear Collegue,
it's possible to swap the RDC card from KRC1 with the RDC card from KRC2?
Thank You
Thank You for reply.
I have swap the above mentionde cards. Robot booted normaly, and I get messages that robot not syncronized, robot name is different etc.
I think that is normaly, but I can't change anything-the function switches on the KCP isn't working. Controll LEDs on the RDC card
are lit (green and red).
Where I made mistake?
I think that I'm back all conectors are on the right place or I need to make some changes in settings?..
Thank You,
p.s.: KRC1
V4.1.7 SP08
KS V4.97
KR125 2 TJ FLOORZH01
you need to load correct data into RDC (robot model, serial number, hours etc)
Hello. You log in as expert and go to SETUP-> robot data or robot name. Then it will ask you which data show the correct values RDC or HARD disk. Then you should choose the hard disk option because you swapped the rdc cards and it will copy data of the robot on hard disk to rdc.
Hello,
thank You for reply.
Procedure that You have described it's known for me, but I can't make any changes because all the function tasters (File, Configure,etc.)
are inactive (I can't log on as expert).
Hello.Then you got some other issues, because generally exchanging the RDC1 card doesn't disables the HMI.It would be easier to help if you could post some pictures of the errors you have on the KCP.
Hola, se puede restablecer la tarjeta rdc?