Good morning. This is my first post with the forum. I work for Lincoln Electric Automation as one of our CRX Tech Support Specialists. I am running into a problem creating a new cell from an MD backup. When I build the cell, I am immediately getting a SYST-212 with multiple changes in the DCS menu. The problem is that these items are not really changed on the actual system. When I try to reapply DCS, I am presented with a message at the bottom stating "Please Exit Verify Screen". Normally it would prompt for the Code. I have a pending conversation with FANUC about this issue that seems to be software related...meaning the WeldPro versions. I have seen this same thing happen with ZI and my current version of ZJ. I do believe the issue is happening with ZK as well, but not 100% sure. Anyone experienced this with WeldPro at all? Any help is appreciated. Thanks.
Controller software version is P50 from the customer's backup. I am seeing this with pretty much every backup I open.