Hello everyone.
I recently bought an old FANUC 3DV/1600 vision camera online without connecting cables. Then I realized that the connector on the back of the camera is not the same as the coaxial connector on the R-30IB cabinet, how do I connect the signal cable between them? Is there an adapter box in between? If you have a camera with this model can you post some photos of the cables for reference. Thank you all.
That camera requires thru arm ASi and vision cable. You'll have to call fanuc and tell them what you have to get a part number.
It also requires 9.30/07 or later software
That camera requires thru arm ASi and vision cable. You'll have to call fanuc and tell them what you have to get a part number.
It also requires 9.30/07 or later software
Thank you very much!
Don't forget the power supply.
Also, that looks like an X-Coded Ethernet cable. You could probably get away with running it with one of those. I think it would then have to plug into the 3rd vision port.
Don't forget the power supply.
Also, that looks like an X-Coded Ethernet cable. You could probably get away with running it with one of those. I think it would then have to plug into the 3rd vision port.
Thank you very much!
How can this camera require 9.4 software when it's so old ?
Where did you get that it is old?
As ROBOT_G mentioned, you do need V9.30 or above on your controller though. And the 3DV iRvision option of course.
