Where it talks about running the program TM 3 times, we are experiencing the issue where it runs the program TM 2 times instead of 3 times. It just stops at the second time of the program and we are not sure where we might be getting stuck at. The issue that we are having is while working with the 50ic 5L model. Working on this program with the ARC Mate 50iD 7L model seems to work. With the 50ic 5L model, it is able to complete the weld path in joint form however it is limited in going down farther while in WORLD mode.
This issue makes me wonder:
- If 50ic 5L model has capability limitations that differ from 50iD 7L and if so, what are those limitations?
- Are there lab exercises in the advanced lab manual that hinder the capability of the 50ic 5L model from completing?